 |
 |
 |
|
|
|
[Sponsors] | ||||
December 19, 2012, 06:20
|
Propeller simulation
|
#1 |
|
New Member
RAM
Join Date: Dec 2012
Posts: 5
Rep Power: 14  |
Hi all,
I am going to 3D flow analysis on 8 bladed aircraft propeller. I came to know that there two ways to do it in fluent. Multiple Rotating Reference frame (MRF) This is done by creating three domains. 1 stationary, in front of the propeller 2. rotating, containing the blades, 3.stationary behind the propeller Single Rotating Reference Frame (SRF) Propeller is stationary and the flow rotates around it (domain is rotating) I would like to know which method is correct method and which method is easy to carry out CFD analysis. |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Propeller calculation | toil | CFX | 19 | July 2, 2025 07:04 |
| Quadrotor helicopter propeller simulation | Attesz | CFX | 14 | December 4, 2017 16:45 |
| Simulation time vs. Simulation Cell Count | chrisoturner | Main CFD Forum | 7 | September 8, 2012 18:46 |
| Propeller Simulation | Craig Paxton | FLUENT | 11 | February 17, 2010 00:57 |
| Replacing mesh while running a simulation | akultane | CFX | 1 | November 15, 2009 14:46 |
Linear Mode
