|
[Sponsors] |
January 30, 2013, 03:23 |
Inflation
|
#1 |
New Member
Bharathwaj
Join Date: Dec 2012
Posts: 2
Rep Power: 0 |
I have meshed a supercritical airfoil in ansys meshing. However, I'm not able to lower my Y+ and the aspect ratio simultaneously. Also, I tried using inflation but that produces irregular mesh, and mapped face meshing is not possible while using inflation. Can someone help me out?
My Y+ lies in 89.3 and aspect ratio around 870. I would like to bring down the aspect ratio without compromising the Y+. PS: I'm trying to simulate transonic flow, using K-e model. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Total Thickness of Inflation Layer | prikeyma | CFX | 5 | August 28, 2020 03:22 |
[ICEM] unwanted pre-mesh inflation around Ogrid | macfly | ANSYS Meshing & Geometry | 7 | September 25, 2012 09:41 |
Large Valve Flow Analysis - Inflation Problem | sercan85 | ANSYS Meshing & Geometry | 2 | June 1, 2010 14:02 |
Inflation | Gab | CFX | 6 | August 24, 2005 22:45 |
inflation | Jennifer Haque | CFX | 2 | June 9, 2004 18:55 |