|
[Sponsors] |
How to set the velocity inlet boundary condition in the compressible flow? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 10, 2013, 15:52 |
How to set the velocity inlet boundary condition in the compressible flow?
|
#1 |
New Member
Yanming LIU
Join Date: Jan 2013
Location: NJ
Posts: 5
Rep Power: 13 |
I know the velocity boundary condition is not available in the compressible flow. But I need to set a velocity disturbance, such as V=sin(t). How can I do this? Do I need to change the velocity profile to mass flow profile and then set the mass flow boundary condition? What should I do? Help, please.
|
|
March 11, 2013, 08:25 |
|
#3 |
New Member
Yanming LIU
Join Date: Jan 2013
Location: NJ
Posts: 5
Rep Power: 13 |
Thanks for your reply. Do you mean that the velocity inlet boundary conditions is also available if the incoming Much number is 1.5?
|
|
Tags |
boundary condition, compressible flow, velocity |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
Problem with assigned inlet velocity profile as a boundary condition | Ozgur_ | FLUENT | 5 | August 25, 2015 04:58 |
Radiation interface | hinca | CFX | 15 | January 26, 2014 17:11 |
velocity inlet vs. moving wall boundary condition | Jane Leous | Main CFD Forum | 0 | September 12, 2008 12:42 |
New topic on same subject - Flow around race car | Tudor Miron | CFX | 15 | April 2, 2004 06:18 |