|
[Sponsors] |
Dissappearing/Missing Boundary Type, What Happened? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 21, 2013, 11:22 |
Dissappearing/Missing Boundary Type, What Happened?
|
#1 |
Member
Join Date: Dec 2012
Posts: 30
Rep Power: 13 |
Why my Fluent 6.2.16 misread the boundary type?
I am sure I already specify the boundary type correctly in my Gambit 2.2.30. But why when analyzed in Fluent 6.2.16, some of these boundary types are missing? |
|
March 22, 2013, 09:18 |
|
#2 |
Senior Member
Paritosh Vasava
Join Date: Oct 2012
Location: Lappeenranta, Finland
Posts: 732
Rep Power: 22 |
Can you explain more about your problem. What exactly are you simulating? Which type of boundary and to which type they are converted?
|
|
March 22, 2013, 11:45 |
|
#3 | |
Member
Join Date: Dec 2012
Posts: 30
Rep Power: 13 |
Quote:
I create the geometry of the wind tunnel as a 2D rectangle in Gambit. And the 2D aerofoil is inside the rectangle. I specify the boundary types as below: left edge of the rectangle is a velocity inlet. right edge of the rectangle is an outflow. top and bottom edges of the rectangle is wall. Why Fluent don't show these boundary types? There are only two option from the "solution initialization" drop down menu (solve > initialize > initialize...), all zones and wall. Also, I can't find all of the four boundary types I already specified earlier in the Gambit, under the Zone of the Boundary Conditions (Define > Boundary Conditions...) instead of default-interior, fluid, and wall. Note that I am using Fluent 6.2.16 |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
boundary conditions for simpleFoam calculation | foam_noob | OpenFOAM Running, Solving & CFD | 8 | July 1, 2015 08:07 |
Need help with boundary conditions: open to atmosphere | Wolle | OpenFOAM | 2 | April 11, 2011 07:32 |
Boundary condition setting for non-premixed combustion using reactingFoam | skyopener | OpenFOAM | 0 | May 23, 2010 22:55 |
pipe flow with heat transfer | Fabian | OpenFOAM | 2 | December 12, 2009 04:53 |
Problem with compile the setParabolicInlet | ivanyao | OpenFOAM Running, Solving & CFD | 6 | September 5, 2008 20:50 |