CFD Online Discussion Forums

CFD Online Discussion Forums (
-   FLUENT (
-   -   Cylinder heat flux (

fluent87 April 16, 2013 06:45

Cylinder heat flux
Hi to Everybody!
I did a Combustion Diesel Two Stoke Engine Simulation, following the Eddie Model Tutorial. In adibatic or isoentropic condition (heat flux and temperature boundary condition set 0). I obtain correct pressure and temperature values.
Now I don't understand how to set heat flux or wall temperature in the model to obtain real value.
If I set like 0 K on wall temperature in boundary condition I obtained good results, but I don't think that is correct.
Somebody could help me?

All times are GMT -4. The time now is 07:16.