|April 16, 2013, 09:34||
How to model a turbulent nozzle
Join Date: Apr 2013
Posts: 1Rep Power: 0
i got a problem modeling a turbulent nozzle:
blue is the inlet with BC pressure inlet 240 00 000 Pa.
red is the outlet with BC pressure outlet 100 000 Pa.
destiny 1860 kg/m3
viscosity 5 kg/m*s (very high)
i choose the rng k-epsilon modell but the volume flow is to low.
my question is if its the right model?
which model do you choose for this problem?
which wall function should i use?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Stability problem due to turbulent dispersion force in a subcooled boiling model||Edy||OpenFOAM||7||August 10, 2011 12:00|
|Turbulent SST model||fergal||CFX||13||November 2, 2010 19:15|
|Low Reynolds k-epsilon model||YJZ||ANSYS||1||August 20, 2010 13:57|
|difference of the laminar and turbulent model||duaiduaihu||FLUENT||0||August 13, 2010 23:40|
|Two-layer turbulent model||maolongliu||OpenFOAM Programming & Development||0||July 27, 2010 11:40|