How to Display a Surface ?

leo_NM · April 16, 2013, 10:03

hey guys.

I'm trying to get familiar with the combo Fluent+ICEM. I managed to do a very poor simulation in one selig 1223 airfoil just to see if all the main steps would be correct. I was playing with Fluent's post-processing, trying to display the contours of pressure and velocity but when I select the contours my mesh is displayed as being the surface.

How can I display a full surface ??

thanks

diamondx · April 16, 2013, 10:55

in contour setup, check "filled"

leo_NM · April 17, 2013, 08:29

Quote:

Originally Posted by diamondx

in contour setup, check "filled"

Solved !! thanks !!

April 16, 2013, 10:55		#2
diamondx Super Moderator Ghazlani M. Ali Join Date: May 2011 Location: Tokyo, Japan Posts: 1,385 Blog Entries: 23 Rep Power: 28	in contour setup, check "filled" __________________ Regards, New to ICEM CFD, try this document --> https://goo.gl/KAOIwm Ali

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Gmsh] Problem with Gmsh	nishant_hull	OpenFOAM Meshing & Mesh Conversion	23	August 5, 2015 02:09
import solids	Alessio85	STAR-CCM+	5	November 11, 2011 13:16
free surface display	carno	Siemens	4	October 7, 2005 01:03
free surface display	andrea mercuri	Siemens	0	July 28, 2004 07:43
free convection heat transfer from a heated horizontal surface through a liquid to a thin cooled fin	Kaushik	FLUENT	1	May 8, 2000 06:47