|
[Sponsors] |
March 20, 2014, 10:09 |
Iteration Problem
|
#1 |
New Member
Join Date: Dec 2013
Posts: 26
Rep Power: 12 |
I am simulating an unsteady 3D transient diesel engine combustion process using Fluent 14.0 installed in windows 7 64-bit system.
I run the simulations using 3 different injection files which are A, B and C. However, after running 548 time-steps and 100 iterations per time-step, simulation A and B works well. Unfortunately, for simulation C, it stopped in the middle of simulation. It stated there "calculating solution" but it never move or calculate further even after 1 or 2 hours. I re-run the same injection file C using 32-bit windows 7 and it works fantastically. Can I know what's going wrong? Any problem or error with this? I attached the picture as below for reference. Thank you. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to increase "Newton Pressure Iteration Limit" | kus | CFX | 9 | April 21, 2013 01:54 |
Can I solve this problem by Fluent? | Kai_kc | FLUENT | 1 | October 27, 2010 05:29 |
The problem of inner iteration when calling the subroutine | guoxj | CFX | 18 | October 23, 2010 20:37 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
Creating, loop or iteration using expression edito | Jan | CFX | 3 | July 28, 2003 11:01 |