Periodic BC and Unstructured Mesh
Hi Everyone,
I have a problem creating periodic boundary conditions. If you know the solutions, please help. I created a geometry in ICEM CFD and tried to create the rotational periodic boundary condition in FLUENT by typing at the interface define>boundary-conditions>modify-zones>make-periodic However, FLUENT shows Warning: differing number of faces on these threads. zone 36: matched 0 out of 4112 faces. zone 35: matched 0 out of 4237 faces. Error: Failed to make zones periodic. Error Objects: #f Can FLUENT create periodic boundary condition on unstructured mesh? It seems to fail because the number of faces on the periodic zone does not match that of the shadow zone. Thank you in advance, Jenny |
Hi,
Does anyone know if FLUENT can create periodic boundary condition on unstructured mesh? It always shows: Error: Failed to make zones periodic. Thanks, Jenny |
Fluent can create periodic boundaries on unstructured meshes but the faces mesh must be conformal
I believe that the user guide lists to steps to make the meshes equal you can also do it with your mesher regards Quote:
|
Hi Jabba,
Thank you for your recommendations. After reading your comment, I followed non-conformal mesh periodic boundary condition steps (rotational) in FLUENT user guide (change boundary condition to interface then create periodic condition in mesh interfaces). However, FLUENT reported the error "couldn't intersect thread 35 and 36". I have checked the offset angle so I don't know what I did wrong. Do you have any suggestions? Thank you, Jenny |
Hello Jenny
I'm not sure about what this error means I would recommend that you make the meshes of the faces you want to make periodic equal using a mesh generator, not fluent this was what I have done with ansys meshing, this is pretty straightforward.. icemcfd should have this capability too then you import the mesh in fluent and just make them periodic through TUI as you tried before regards |
All times are GMT -4. The time now is 12:30. |