|
[Sponsors] |
![]() |
![]() |
#1 |
Member
Join Date: Aug 2011
Posts: 87
Rep Power: 13 ![]() |
I am working with a sliding mesh to simulate a fan. I am using a mesh interface between the moving zone and the non-moving zone. However, fluid does not appear to be passing through the zone, and the simulation diverges after about 20 iterations. Has anyone seen this before?
I have gotten this to work recently, then I changed the geometry, remeshed, and used the same settings. This time however, no luck. I think this is a bug, but possible I am making a simple mistake. Has anyone seen this before? |
|
![]() |
![]() |
![]() |
![]() |
#2 |
New Member
sina
Join Date: Sep 2011
Posts: 28
Rep Power: 13 ![]() |
Dear Mach zero
what is your boundary condition in inlet and outlet? is divergence on mass balance? Regards |
|
![]() |
![]() |
![]() |
![]() |
#3 |
New Member
Join Date: Jun 2013
Posts: 6
Rep Power: 11 ![]() |
Hi MachZero
you should check interface bc in your mesh generation software. first plz check element size of mesh in two sides of interface. |
|
![]() |
![]() |
![]() |
Tags |
sliding interface |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 02:13 |
[ICEM] domain interface in ICEM for fluent | hsn | ANSYS Meshing & Geometry | 24 | November 27, 2012 17:43 |
[DesignModeler] Geometry working in GAMBIT but not FLUENT | CDollarsign | ANSYS Meshing & Geometry | 5 | September 13, 2012 10:29 |
Fluent jobs through pbs | ibnkureshi | FLUENT | 5 | June 9, 2011 14:43 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 16:55 |