|
[Sponsors] |
June 18, 2013, 23:39 |
Help with Cell Zones
|
#1 |
Member
Arthur Loginow
Join Date: Aug 2012
Posts: 99
Rep Power: 13 |
I have tried a lot of different thinks to create a mesh where FLUENT can recognize the different cell zones, but so far I have not been able to achieve that, so far It recognize everything except the 3 different cell zones that I am trying to create, the last thing that I did was to use the Slice option at the DM to create 3 different areas (or parts), but to do that I had to create 2 lines from sketches, I think that there is my mistake, but I need someone to correct me, this is a simple 2D problem, please someone help me. Any tutorial/guide/material will be appreciated but I have not been able to find anything at the DM/Meshing level all the information that I was able to found was at the Fluent level, and my problem is before that.
Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] how to extract cell zones by cgnsToFoam | Ohbuchi | OpenFOAM Meshing & Mesh Conversion | 0 | July 22, 2010 04:19 |
Cells with t below lower limit | Purushothama | Siemens | 2 | May 31, 2010 21:58 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
Warning 097- | AB | Siemens | 6 | November 15, 2004 04:41 |
Tracking/Modifying Cell Zones | Greg Perkins | FLUENT | 1 | November 6, 2000 23:35 |