How to simulate a fan inside a domain

asal · June 21, 2013, 09:16

Hello every body.

I have two pipe within my geometry. The airflow was supplied over the inlet 1 and extracted out by outlet 1.
There is a fan in the inner pipe which suck the flow in the inner pipe from outlet 2 and extracted to the main pipe from outlet 2. the flow can pass also from the gap between the shell of inner/outer pipes. How can I specify the boundary condition of inlet/outlet 2? Note that we have no any flow properties at the inlet/outlet 2 except velocity.
I think it is possible to do it with fan-zone, but I cannot find any example for it.
I am appropriate if someone can give me a hand in the case.

Thanks.

Far · June 23, 2013, 06:52

Use fan condition and specify pressure jump. Be careful in selecting sign for pressure jump.

asal · June 23, 2013, 10:31

I did it already. the problem is the flow is pass throw the walls which I specify to the boundaries around the fan zone. I want flow just passing throw the inlet, outlet of the fan zone, not the walls.
do you have any solution for this issue?

June 21, 2013, 09:16	How to simulate a fan inside a domain	#1
asal Senior Member Astio Lamar Join Date: May 2012 Location: Pipe Posts: 186 Rep Power: 13	Hello every body. I have two pipe within my geometry. The airflow was supplied over the inlet 1 and extracted out by outlet 1. There is a fan in the inner pipe which suck the flow in the inner pipe from outlet 2 and extracted to the main pipe from outlet 2. the flow can pass also from the gap between the shell of inner/outer pipes. How can I specify the boundary condition of inlet/outlet 2? Note that we have no any flow properties at the inlet/outlet 2 except velocity. I think it is possible to do it with fan-zone, but I cannot find any example for it. I am appropriate if someone can give me a hand in the case. Thanks. Last edited by asal; June 23, 2013 at 10:33.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Domain Reference Pressure and mass flow inlet boundary	AdidaKK	CFX	75	August 20, 2018 05:37
inlet velocity boundary condition	murali	CFX	5	August 3, 2012 08:56
ATTENTION! Reliability problems in CFX 5.7	Joseph	CFX	14	April 20, 2010 15:45
RPM in Wind Turbine	Pankaj	CFX	9	November 23, 2009 04:05
New topic on same subject - Flow around race car	Tudor Miron	CFX	15	April 2, 2004 06:18

June 23, 2013, 06:52		#2
Far Super Moderator Sijal Join Date: Mar 2009 Location: Islamabad Posts: 4,553 Blog Entries: 6 Rep Power: 54	Use fan condition and specify pressure jump. Be careful in selecting sign for pressure jump.

June 23, 2013, 10:31		#3
asal Senior Member Astio Lamar Join Date: May 2012 Location: Pipe Posts: 186 Rep Power: 13	I did it already. the problem is the flow is pass throw the walls which I specify to the boundaries around the fan zone. I want flow just passing throw the inlet, outlet of the fan zone, not the walls. do you have any solution for this issue?