|
[Sponsors] |
June 25, 2013, 19:58 |
Heat Flux Doesn't Work
|
#1 |
New Member
Ryan Z. Davis
Join Date: Mar 2010
Location: Idaho Falls, Idaho, United States
Posts: 11
Rep Power: 16 |
Hi all,
I can't tell what I'm doing wrong. I'm trying to model 2D turbulent flow through a pipe. The lower wall of the pipe is held at a constant temperature and the upper wall has a heat flux of 7.795 W/m^2. When I run the simulation it appears there is no heat transfer through the upper wall. I should be dumping A LOT of heat into the fluid, but the result of the simulation shows almost a constant temperature along the upper wall. Please Help, -Ryan |
|
June 26, 2013, 12:13 |
|
#2 |
New Member
Ryan Z. Davis
Join Date: Mar 2010
Location: Idaho Falls, Idaho, United States
Posts: 11
Rep Power: 16 |
This doesn't seem like it should be a very difficult problem. Can't anyone help?
|
|
Tags |
fluent, heat flux, turbulent flow |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wall Heat Flux & Temperature | Greg Perkins | FLUENT | 10 | November 20, 2015 10:32 |
Heat Flux at wall in a conjugate heat transfer problem | Chander | CFX | 2 | July 9, 2011 23:22 |
Heat flux in ansys cfx | juliom | OpenFOAM Running, Solving & CFD | 2 | April 14, 2009 15:30 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 16:55 |
heat flux to heat rejection | azmir | Siemens | 0 | June 23, 2004 21:53 |