Home > Forums > Software User Forums > ANSYS > FLUENT

Mass flow

Mark Forums Read

Reply

Search this Thread

July 21, 2013, 09:41	Mass flow	#1
mehdimoradi. Member mehdimoradi Join Date: Jun 2013 Posts: 53 Rep Power: 12	Hello everybody I have a question, Please help me. I am doing simulation a multiphase project (air and 2 solids). I have 3 inlet B.Cs and 2 outlet B.Cs. out lets are as pressure outlet B.Cs. In experiment, solids enter hopper and exit continuously whereas in post processing mass flow out let of solid phases are zero. Why?

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
mass flow inlet and pressure outlet with target mass flow rate	Zigainer	FLUENT	13	October 26, 2018 05:58
Convergence problem with target mass flow rate	ADL	FLUENT	2	May 29, 2012 21:11
mass flow	Wenbin Song	FLUENT	0	September 27, 2005 13:00
Determine mass flow rate along flow path	Atit Koonsrisuk	CFX	2	October 5, 2003 04:47
Mass Flow Inlet	Pravir Kumar Rai	FLUENT	0	February 19, 2003 14:03

All times are GMT -4. The time now is 04:32.