|
[Sponsors] |
interpolate results from two phase to one phase. HOW???? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 29, 2013, 16:13 |
interpolate results from two phase to one phase. HOW????
|
#1 |
Senior Member
navid
Join Date: Jan 2010
Posts: 110
Rep Power: 16 |
Hi,
I am doing a two phase simulation using VOF. An air bubble inside water. At the end I want to write pressure and velocity values and read them in another simulation for only water using interpolation. Can I do this from a two phase solution to a one phase?? |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Extract primary phase thread in VOF with 3 phases | Eric | FLUENT | 2 | July 7, 2011 02:22 |
Source Term used in Eulerian Model(Two phase) | Padian | FLUENT | 1 | May 19, 2008 03:47 |
How to activate just one phase turbulence model? | Trodeme | FLUENT | 1 | January 26, 2007 14:50 |
Slip boundary condition giving strange results | hemph | OpenFOAM Running, Solving & CFD | 3 | January 18, 2007 05:15 |
Defining a non-granular phase | Tom | FLUENT | 8 | September 19, 2003 11:52 |