Fluent job does not stop when submitting it via qsub
Hello!
When I run transient Fluent case file in batch mode and the calculation fails due to divergence or some other issues, the execution stops by itself, which is fine. The command I use is Code:
/share/ansys_12.1/v121/fluent/bin/fluent 3ddp -g -t30 < command_script >& outputfile & How can I make the job stop on its own in case of divergence or exception, as it normally should do? The command I use inside qsub file is Code:
/share/ansys_12.1/v121/fluent/bin/fluent 3ddp -g -t$NCPU -cnf=$PBS_NODEFILE -pib -i command_script 2>&1 > outputfile Thanks. |
This divergence in AMG solver is a common case. Change your pressure solution method to standard and run. After trying, post how it is.
|
Thanks for advice, I may use it, but my question was different.
How do I make qsub stop in case of divergence? And what do you mean standard? Is it density based type? Will it be good for two-phase VOF simulation, in which one fluid is copmpressible and the other is not? |
Put
Code:
/file/set-batch-options no yes no In fact the only the second "yes" matters. |
Quote:
Code:
file/sbo yes yes no |
All times are GMT -4. The time now is 07:55. |