|
[Sponsors] |
model information file is not compatible with mesh - named selections |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 23, 2013, 05:19 |
model information file is not compatible with mesh - named selections
|
#1 |
New Member
Tamara Annabelle
Join Date: Jul 2013
Posts: 26
Rep Power: 12 |
Hi!
I have a problem with importing named seletions from the mesh to the FLUENT setup. The model is in 2d. I created named selections in the DM which I need for meshing. I don't need all of them for the solution though and thus activated "No" in the box "send to solver" for the named selctions not needed. But when I open the model in FLUENT, I get the error message "model information file is not compatible with mesh" and I am beeing asked if I 'would like to match these zones to make model compatible with mesh' Does any one else know how to solv it? I apreciate your answers, Mara |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to calculate mass flow rate on patches and summation of that during the run? | immortality | OpenFOAM Post-Processing | 104 | February 16, 2021 08:46 |
[OpenFOAM] Annoying issue of automatic "Rescale to Data Range " with paraFoam/paraview 3.12 | keepfit | ParaView | 60 | September 18, 2013 03:23 |
[blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 09:56 |
ParaView Compilation | jakaranda | OpenFOAM Installation | 3 | October 27, 2008 11:46 |
error while compiling the USER Sub routine | CFD user | CFX | 3 | November 25, 2002 15:16 |