 |
 |
 |
|
|
|
[Sponsors] | ||||
Help with heat sink design [2D] Convergence Issue |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 17, 2013, 00:06
|
Help with heat sink design [2D] Convergence Issue
|
#1 |
|
New Member
Ikhsan
Join Date: Sep 2013
Posts: 15
Rep Power: 12  |
I created a design for heat sink.
I checked the mesh quality in Gambit. The element with the worst aspect ratio value was 2.52411 The element with the worst EquiAngle/EquiSize skew value was 0.475992. From what I understand my meshes are fine, however I am still unable to get convergence after 1000 iterations. Attached the model and mesh quality for reference. What can I do for it to converge? |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Error finding variable "THERMX" | sunilpatil | CFX | 8 | April 26, 2013 07:00 |
| Help modeling heat sink | aimee | FLUENT | 1 | June 3, 2011 14:17 |
| Forced convection heat transfer in heat sink | Sidy | FLUENT | 1 | October 18, 2008 03:27 |
| heat transfer problems of a heat sink | tina | FLUENT | 2 | August 13, 2008 06:11 |
| Two-Phase Buoyant Flow Issue | Miguel Baritto | CFX | 4 | August 31, 2006 12:02 |
Linear Mode
