[wiggles8x0]

Hi all,
Has anyone ever ran a fluent meshing job on a linux based cluster?

I have a journal file ready which goes through the entire process for my geometry but I'm having trouble getting the journal file to be read by the cluster. I don't get any sort of error, it just stops with a blank .out and .err file which isn't very helpful. So I'm wondering if there is an additional line of code that I need to put at the beginning of my journal file that it is currently missing or something?

One thing that I did notice is that in my journal file, all the commands are based on using the gui. For example:

(cx-gui-do cx-activate-item "MenuBar*WriteSubMenu*Start Transcript...")

The cluster doesn't support GUI so this too may cause an issue down the road. I'm just not sure how to convert the journal file from GUI based commands to the non-GUI based commands. So any help with that too would be appreciated!

Many thanks!