|
[Sponsors] |
October 2, 2013, 04:47 |
Two interior regions in fluent
|
#1 |
Member
Prateek Anand
Join Date: Nov 2012
Posts: 34
Rep Power: 13 |
Hey all,
I am using Ansys Fluent.The geometry used has branches.Mesh seems well and good.When I open the mesh in ansys fluent,it shows TWO "interior" regions instead of ONE "interior".Only a single fluid is used in the geometry. What could the error possibly be? Thnx. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Connecting Fluent benefits and Injection Molding Software | Jim87 | FLUENT | 1 | August 6, 2023 16:06 |
Two questions on Fluent UDF | Steven | Fluent UDF and Scheme Programming | 7 | March 23, 2018 03:22 |
heat transfer with RANS wall function, over a flat plate (validation with fluent) | bruce | OpenFOAM Running, Solving & CFD | 6 | January 20, 2017 06:22 |
Alias problem when starting FLUENT from command line | batch_error | FLUENT | 0 | May 24, 2012 08:20 |
Problems in lauching FLUENT | Lourival | FLUENT | 3 | January 16, 2008 16:48 |