3D fluent analysis
I am working in a 3D wind rotor,modelled it in creo 2.0 and imported it to design modeller to draw the enclosure.I enclosed the rotor within a cylinder which again enclosed within a cuboid to give the boco's.
I did meshing in ansys mesh itself...but when I exported to fluent...it is not taxing the file,showing error as:
"Model information is incompatible with the incoming mesh"
I think it has got some problem with named selection...but I am totally blank regarding what could be done.
Plz I need help....thnx in advance.
|All times are GMT -4. The time now is 01:44.|