 |
 |
 |
|
|
|
[Sponsors] | ||||
October 16, 2013, 07:28
|
problem with Axisymmetry simulation
|
#1 |
|
New Member
zain
Join Date: Oct 2013
Posts: 1
Rep Power: 0  |
hi
I'm working on simulation of fluid in cylindrical vessel . I used Axisymmetric for that . when i run the calculation it keep giving (Error: Divergence detected in AMG solver: x-momentum) ,i used a fine mesh and reduced under relaxtion factor to 0.1 and it still give the same error . when i switched to cartesian with the same setting it give the solution and the convergence was established ! can u help me please with this thanx in advance |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem in initializing transient simulation with a finer mesh | sidd | CFX | 8 | April 29, 2016 02:25 |
| Low pressure de Laval simulation convergence problem | heksel8i | FLUENT | 3 | July 22, 2013 10:28 |
| Dynamic mesh simulation (pimpleDyMFoam) problem | sidlof | OpenFOAM Running, Solving & CFD | 6 | April 12, 2013 11:24 |
| Problem with interface in a wind turbine simulation | be_inspired | FLUENT | 2 | March 7, 2011 23:46 |
| Problem about 3D blunt body high Re simulation | David | FLUENT | 0 | September 27, 2002 10:59 |
Linear Mode
