Unspected Error while initilization

Aliset1236 · November 11, 2013, 02:44

Nowadays when I try to initialize my model I encounter with this message

ghost82 · November 11, 2013, 07:11

are you using udf?

Aliset1236 · November 12, 2013, 07:43

Yes Sir
I utilize Fuel cell Addin Module

ghost82 · November 12, 2013, 12:23

Hi,
I don't know that module and never used it; are you trying to initialize your solution by clicking on "compute from"?
If so, initialize without clicking on it.
If problem persist you have errors in your udf.

Daniele

Aliset1236 · November 12, 2013, 12:31

Hi
Dear Daniele
thank you very much for your attention and what do you mean by initialize without clicking and then this udf is installed by Ansys Original file
sincerely

ghost82 · November 12, 2013, 13:03

Sorry, I mean initialize by clicking on solution initialization, then DON'T click on compute from, but write your initialization values and then click initialize.
Then start calculating, if error happens as soon as you click on start calculating, I think you have errors in your udf code.

Daniele

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
About initilization and also compiling	Ali (Ali)	OpenFOAM Pre-Processing	11	April 7, 2011 09:36
Initilization at subdomain	Jaho	CFX	3	March 30, 2009 00:58
Solution Initilization	Vijay	FLUENT	0	February 12, 2009 18:23
Unsure on Initilization and ref values	Alex	FLUENT	0	August 10, 2008 21:45

November 11, 2013, 07:11		#2
ghost82 Senior Member Rick Join Date: Oct 2010 Posts: 1,016 Rep Power: 26	are you using udf?

November 12, 2013, 07:43		#3
Aliset1236 New Member Alireza Setayesh Hagh Join Date: Nov 2013 Posts: 8 Rep Power: 12	Yes Sir I utilize Fuel cell Addin Module

November 12, 2013, 12:23		#4
ghost82 Senior Member Rick Join Date: Oct 2010 Posts: 1,016 Rep Power: 26	Hi, I don't know that module and never used it; are you trying to initialize your solution by clicking on "compute from"? If so, initialize without clicking on it. If problem persist you have errors in your udf. Daniele

November 12, 2013, 12:31		#5
Aliset1236 New Member Alireza Setayesh Hagh Join Date: Nov 2013 Posts: 8 Rep Power: 12	Hi Dear Daniele thank you very much for your attention and what do you mean by initialize without clicking and then this udf is installed by Ansys Original file sincerely

November 12, 2013, 13:03		#6
ghost82 Senior Member Rick Join Date: Oct 2010 Posts: 1,016 Rep Power: 26	Sorry, I mean initialize by clicking on solution initialization, then DON'T click on compute from, but write your initialization values and then click initialize. Then start calculating, if error happens as soon as you click on start calculating, I think you have errors in your udf code. Daniele