|
[Sponsors] |
Change operating pressure without redoing simulation |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 29, 2013, 04:00 |
Change operating pressure without redoing simulation
|
#1 |
Senior Member
Join Date: Nov 2013
Posts: 1,965
Rep Power: 26 |
I have done a time-consuming simulation, that finally converged, and it was done at an operating pressure of 100 Pa.
Now I have to append it to a second simulation, that was run at an operating pressure of 200 Pa... Is there an easy way to change the results in my first Fluent simulation, such that the operating pressure is increased by 100 Pa, and the guage pressures decreased by 100 Pa, so that physically it remains the same solution? The difficult way is doing the simulation again at a different operating pressure, but I hope to avoid that... |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Pressure Outlet for phase change simulation | dinesh | FLUENT | 0 | November 21, 2013 23:50 |
Transient simulation (Problem with massflow and Pressure) | ChristianF | CFX | 4 | August 22, 2011 21:42 |
OPERATING PRESSURE | manish | FLUENT | 6 | February 25, 2011 04:40 |
Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 09:11 |
Hydrostatic pressure in 2-phase flow modeling (long) | DS & HB | Main CFD Forum | 0 | January 8, 2000 15:00 |