|
[Sponsors] |
December 14, 2013, 15:51 |
Flame sticking to the tube
|
#1 |
New Member
shashank vummidi
Join Date: Jan 2013
Posts: 1
Rep Power: 0 |
Hello,
I am trying to model a partially premixed acetylene-air flame for a custom burner. The simulation is a 2d axisymmetric model. I have 1 major problem ... my flame sticks to inside of the tube. I have modeled only the fluid volume. Attached is an image of my problem. I need to simulate a flame that sits on the exit of the inlet tube. Any help is greatly appriciated. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
HLL Riemann Shock Tube Matlab Problem | Luke F | Main CFD Forum | 2 | May 20, 2016 02:10 |
[OpenFOAM] Tube filter in Paraview | werweisswas | ParaView | 0 | December 10, 2012 06:18 |
[Other] How to set up a dynamic mesh for a piston moving through a tube of variable diameter? | karkar | OpenFOAM Meshing & Mesh Conversion | 0 | July 4, 2012 06:54 |
Hydraucone Draft Tube CFD | tojoe999 | OpenFOAM | 0 | March 5, 2012 13:10 |
Tube inside a tube simulation | Rashmichem | Main CFD Forum | 0 | December 14, 2010 01:52 |