How to setup simulation of injet Helium into Air cell zone?
Dear Fluentian,
I am new in the realm of Fluent and still reading the user guide. Would you please inspire me how to setup to simulate helium is been injet into a cell zone with air inside? (Also there is another hole as pressure outlet) I tried to chose species model (species transport or non-premixed combustion? ) Also I an in trouble when setting up the boundary condition. when setting the mass-flow-inlet boundary, the "species" option showed "this page in not applicable under current setting" Oppsssss..... Please help, I tried the figure it out how to setup during this chrismas holiday, but so far no any progress ----Shogan |
I have same problem with you. have you found solution yet
|
If i remember correctly, you have to use mass source term and most likely a UDF to be able to inject into a specific cell in the flow Domain.
Read the Fluent Manual on how this is done. It might be helpful. Jimmy |
All times are GMT -4. The time now is 18:43. |