|
[Sponsors] |
January 6, 2014, 06:18 |
modeling thermal storage tank
|
#1 |
New Member
amel
Join Date: Oct 2010
Posts: 13
Rep Power: 15 |
Hi
I would like to model side by side hot water tubes placed at the surface of the soil under an air collector (a part of a s.olar chimney) (see figure). I have created a 2D geometry in Gambit. the problem is that the water enters the tube to heat the air under the collector and exit it. How can I model the entrance and exit of 2D tube (presented in Gambit by a cercle) FLUENT? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
advice for modeling water tank | ryan_c | OpenFOAM Running, Solving & CFD | 1 | November 15, 2012 16:42 |
Dynamic sloshing and hydrodynamic modeling of liquid storage tank for earthquake | K i M | Main CFD Forum | 14 | April 22, 2011 22:24 |
Liquid Storage tank | puneetiscool2006 | ANSYS | 5 | December 11, 2010 15:24 |
Modeling Thermal Radiation | Kaushik Saha | FLUENT | 0 | September 17, 2008 19:12 |
Info: Short Course On Thermal Design of Electronic Equipment | Arnold Free | Main CFD Forum | 0 | August 10, 1999 10:18 |