|January 8, 2014, 04:34||
Fluid Sticking to the wall with Eulerian multiphase model
Join Date: Oct 2012
Location: Lappeenranta, Finland
Posts: 713Rep Power: 15
I have been learning to simulate 3 phase flows with Eulerian multiphase model in Fluent (v13 and v14). I am looking to simulate fibres or oil type of substance that stick to the walls of a tank during draining process.
So far in my simulations I do get separation of the phases and flow distributions correct but I have had any success in getting the phases sticking to the wall.
My question is what parameters in the setup I should be looking more carefully get the fluid stick to the wall??
|Thread||Thread Starter||Forum||Replies||Last Post|
|Eulerian wall film model with DPM||dan86||FLUENT||5||June 13, 2016 03:26|
|Enhanced Wall Treatment||paduchev||FLUENT||19||April 10, 2016 09:57|
|mass flow in is not equal to mass flow out||saii||CFX||2||September 18, 2009 08:07|
|Concentric tube heat exchanger (Air-Water)||Young||CFX||5||October 6, 2008 23:17|
|Terrible Mistake In Fluid Dynamics History||Abhi||Main CFD Forum||12||July 8, 2002 09:11|