|
[Sponsors] |
January 22, 2014, 10:32 |
Surface Roughness
|
#1 |
New Member
magnus nytun
Join Date: Sep 2012
Posts: 9
Rep Power: 13 |
Hi
I need to add surface roughness in the form of long spanwise square rods to the floor of my 3D diffuser. Is this possible by utilizing the roughness function in the setup menu, or must I create a new floor and then draw in every roughness element and push extrude to get 3D. Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Problems with coedge curves and surfaces | tommymoose | ANSYS Meshing & Geometry | 6 | December 1, 2020 11:12 |
Surface Roughness Laminar Flow | cmh | OpenFOAM Pre-Processing | 0 | July 10, 2013 07:19 |
Decreasing surface roughness in a pipe | pat | FLUENT | 0 | June 12, 2006 11:22 |
CCM+ Surface Roughness | AJ | Siemens | 3 | March 8, 2006 18:14 |
Setting a surface roughness on a wall | Sandile Peta | FLUENT | 3 | February 1, 2006 08:14 |