 |
 |
 |
|
|
|
[Sponsors] | ||||
January 28, 2014, 06:56
|
Mesh Interface Option
|
#1 |
|
New Member
bhaskar
Join Date: Jan 2014
Posts: 3
Rep Power: 13  |
I am using solid and fluid overlapping cell zone case in Ansys Fluent but Mesh Interface option is not get activated. Kindly help me.
|
|
|
|
|
|
February 4, 2014, 12:31
|
mesh interface or contact regions
|
#2 |
|
New Member
Join Date: Dec 2013
Posts: 11
Rep Power: 13 |
You must set the contact regions or connections settings in ansys meshing module by specifying the the threshold distance between any 2 edges or any 2 faces. If you didn't do this in the meshing module, there is no chance that you could proceed to ansys fluent. You might have deleted a contact region in meshing module.
|
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 06:21 |
| Simulation of a single bubble with a VOF-method | Suzzn | CFX | 21 | January 29, 2018 01:58 |
| emag beta feature: charge density | charlotte | CFX | 4 | March 22, 2011 10:14 |
| increasing mesh quality is leading to poor convergence | tippo | CFX | 2 | May 5, 2009 11:55 |
| about compresive phase | James | CFX | 10 | September 12, 2006 04:16 |
Linear Mode
