|
[Sponsors] |
July 16, 2014, 04:54 |
left-handed faces on the sliding interface
|
#1 |
Member
Join Date: Nov 2013
Posts: 57
Rep Power: 12 |
hi guys,
I am simulating a 3D centrifugal compressor, at first I got a convergence solution with steady mode, (moving reference) and now I wanna simulate in unsteady mode, (mesh motion). when I wanna check the rotation before running,(mesh motion preview), I face with this warning in fluent: Warning: Failed to correct face handedness of 520 out of 672 left-handed faces on the sliding interface zone 29. any suggestion ? Many thanks, |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] Mesh Importing Problem | cuteapathy | ANSYS Meshing & Geometry | 2 | June 24, 2017 06:29 |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 10:38 |
Left handed faces created by adaptive mesh | RagingPotato | FLUENT | 0 | April 3, 2012 13:29 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 05:05 |
Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 21:09 |