|
[Sponsors] |
November 19, 2013, 07:13 |
spray nozzle
|
#1 |
New Member
---
Join Date: Dec 2012
Location: Turkey
Posts: 8
Rep Power: 13 |
Hi all!
I have been trying my studies which is related about steel plate cooling. I have completed settings which is necessary also injection. In spite of i defined cone angle i can not see this angle in the result graphis. It seems smaller then angle which was defined by myself. I used Multiphase ( air + water) Species Transport DiscretePhase for ijection. |
|
February 6, 2014, 05:07 |
|
#2 |
New Member
Shiva
Join Date: Jan 2014
Posts: 1
Rep Power: 0 |
I'm not sure about the cone angle, but why are you using Multiphase models if there is a DPM injection ? Ins't the carrier medium just air ? Also, why species transport ?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Which phase is dispersed in pre and post nozzle spray? | Torque_Converter | CFX | 6 | February 21, 2013 16:24 |
Coupling spray simulation with nozzle flow | zaer | OpenFOAM Running, Solving & CFD | 1 | March 16, 2012 04:43 |
CFD of Plasma Spray nozzle | pblee_99 | FLUENT | 0 | August 5, 2010 10:09 |
compressible flow in a counterflow nozzle | d.vamsidhar | FLUENT | 0 | November 24, 2005 01:45 |
water spray nozzle | Dr. Insoo Cho | Main CFD Forum | 3 | October 15, 1999 14:53 |