|February 8, 2014, 17:45||
Validation of a Micro Channel Heat Sink
Join Date: Feb 2014
Posts: 1Rep Power: 0
I'm new to Ansys FLUENT.
I am modelling a micro channel heat sink.
Everything is done, except that i am supposed to get a temperature difference (from inlet to outlet) of 30 kelvin. Right now i am getting a temperature difference of only 10 kelvin.
In ideas where i could be making mistakes?
Or i could improve
|conjugate heat transfer, heat sink, micro channel|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Heat transfer, natural convection: Heat sink <-> Air||SvenH||OpenFOAM||9||November 13, 2013 05:35|
|Enforce bounds error with heat loss boundary condition at solid walls||Chander||CFX||2||May 1, 2012 20:11|
|Heat Pipe Validation Test||Miky1020||Main CFD Forum||0||September 4, 2009 12:29|
|Reply me if u did heat sink analysis||siva||FLUENT||0||January 5, 2009 08:07|
|Forced convection heat transfer in heat sink||Sidy||FLUENT||1||October 18, 2008 03:27|