|
[Sponsors] |
February 28, 2014, 09:33 |
ways to output a case file?
|
#1 |
New Member
Nick Prendergast
Join Date: Dec 2013
Posts: 28
Rep Power: 12 |
Hey Guys,
I have a .msh file with the from Icem with greater than a million volumes but I'm using an academic licence which only runs problems with about half that number. I have access to a high performance computer with a research licence but to make use of it I need to have a .cas file. When I try to open the .msh file in fluent it comes up with an error and I can't write the .cas file from there. I am unsure of what to do from there and any help would be appreciated greatly. Thanks Nick |
|
March 4, 2014, 09:14 |
|
#3 |
New Member
Nick Prendergast
Join Date: Dec 2013
Posts: 28
Rep Power: 12 |
The error message said the number of elements was too big for the licence I was using. I have since been able to sort out the problem though. I did it by using workbench as an intermediate step where I was able to adjust the licence settings and now I can open the the .msh file in fluent and export a .cas file after putting in the BCs and solver etc.
Thanks for your help. Nick |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
simpleFoam parallel | AndrewMortimer | OpenFOAM Running, Solving & CFD | 12 | August 7, 2015 18:45 |
[swak4Foam] Swak4FOAM 0.2.3 / OF2.2.x installation error | FerdiFuchs | OpenFOAM Community Contributions | 27 | April 16, 2014 15:14 |
patch error OF v2.2.2 mac | hewei | OpenFOAM Installation | 4 | November 30, 2013 16:55 |
Trouble compiling utilities using source-built OpenFOAM | Artur | OpenFOAM Programming & Development | 14 | October 29, 2013 10:59 |
pisoFoam compiling error with OF 1.7.1 on MAC OSX | Greg Givogue | OpenFOAM Programming & Development | 3 | March 4, 2011 17:18 |