Falling flim over inclined plane problems -- CFD Online Discussion Forums

March 7, 2014, 19:14	Falling flim over inclined plane problems	#1
Eakarach Member Join Date: Aug 2013 Location: Bangkok Posts: 32 Rep Power: 12	Dear all I try to simulate falling flim over inclined plane with 30 degree from horizontal. The domain has a width of 18 m and heigth of 1 m as reported in ansys fluid dynamics verification manual. The boundary conditions were identical with this manual. However, the results are difference. Can anyone help me to solve this. Thank in advance Regards Eakarach

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Problems with coedge curves and surfaces	tommymoose	ANSYS Meshing & Geometry	6	December 1, 2020 11:12
Problems in the deployment temperature	Zero	CFX	8	December 23, 2013 06:35
Problems to sample a plane (X-Y-Plane) through the Fluid	despaired student	OpenFOAM Running, Solving & CFD	4	September 27, 2013 06:35
Problems with BCs in muliphase flow with water falling from a reservoir	Paul_l	FLUENT	2	March 11, 2011 04:59
Problems modeling subsonic engine air inlet with flow separation	TWaung	CFX	2	March 29, 2009 18:42

All times are GMT -4. The time now is 03:06.