 |
 |
 |
|
|
|
[Sponsors] | ||||
March 12, 2014, 07:59
|
How to mesh the heat-exchanger using Tgrid
|
#1 |
|
New Member
ethen
Join Date: Jun 2012
Posts: 12
Rep Power: 15  |
Hi,could anybody give me some suggestion? i got a big question,when i used hypermesh to generated surface mesh of heatexchange, i got volume mesh of this exchange by offset menu, i extracted one face to monitor airflow at same time,and input this result (*.nas) to Tgrid,could anybody tell me how to process the type of exchanger?
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Commercial meshers] Cannot convert fluent or tgrid hexcore mesh | aerogt3 | OpenFOAM Meshing & Mesh Conversion | 2 | October 22, 2010 11:55 |
| cooper mesh coarsening with tri meshed source | Ralf Schmidt | FLUENT | 2 | January 31, 2008 08:50 |
| TGrid: segmentation violation error | Vincent | FLUENT | 0 | February 15, 2006 10:34 |
| Drawing in TGrid | Harmeet | FLUENT | 0 | September 22, 2004 03:56 |
| meshing F1 front wing | Steve | FLUENT | 0 | April 17, 2003 12:37 |
Linear Mode
