 |
 |
 |
|
|
|
[Sponsors] | ||||
March 11, 2014, 06:55
|
Negative volume
|
#1 |
|
New Member
Jack Holmes
Join Date: Feb 2014
Posts: 9
Rep Power: 12  |
Hi,
I am getting a negative volume when I preview my dynamic mesh on fluent. I have tried all the TUI commands to fix it but this does not help. Can anybody take a look at my mesh for me and see if they can find the error. Thankyou Jack |
|
|
|
|
|
March 13, 2014, 08:33
|
|
#2 |
|
Senior Member
Paritosh Vasava
Join Date: Oct 2012
Location: Lappeenranta, Finland
Posts: 732
Rep Power: 22 |
Try using a smaller time step. Just make sure that motion of the mesh does not exceed the size of your mesh elements.
|
|
|
|
|
|
 |
| Tags |
| cylinder, dynamic mesh, fluent, negative volume |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Turbogrid and Negative volume | Ali | CFX | 12 | August 18, 2016 14:31 |
| FLUENT negative volume | eishinsnsayshin | FLUENT | 1 | March 27, 2012 04:03 |
| [blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 09:56 |
| remeshing due to negative volume error | Doginal | CFX | 1 | August 21, 2011 21:50 |
| fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
Linear Mode
