Home > Forums > Software User Forums > ANSYS > FLUENT

modeling of flow in porous where water level is below the top of the aggregate level

Mark Forums Read

Reply

Search this Thread

March 23, 2014, 16:07	modeling of flow in porous where water level is below the top of the aggregate level	#1
Tanjina Senior Member Tanjina Afrin Join Date: May 2013 Location: South Carolina Posts: 169 Rep Power: 14	Hello everyone. Does anyone have any idea how to do model unsaturated( where water level is lower than the height of the aggregate) flow in porous medium using Fluent ? I am using VOF but facing some problem. Thanks in advance. Regards, Tanjina

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
modeling the fluid flow in porous media by Fluent	Mohsen Nazari	FLUENT	5	April 26, 2019 05:45
Discontinuity at water level in stratified 2 phase flow	kbaker	CFX	24	June 14, 2012 08:37
CFD Modeling of Two-phase Flow in Small Dia.Tubes	Eric Poindexter	Main CFD Forum	2	September 22, 2000 10:21
fluid flow fundas	ram	Main CFD Forum	5	June 17, 2000 22:31
Hydrostatic pressure in 2-phase flow modeling (long)	DS & HB	Main CFD Forum	0	January 8, 2000 16:00

All times are GMT -4. The time now is 03:16.