Home > Forums > Software User Forums > ANSYS > FLUENT

Enquiry about initialisation in Fluent

Mark Forums Read

Reply

Search this Thread

March 24, 2014, 08:45	Enquiry about initialisation in Fluent	#1
dotapro Member Join Date: Oct 2013 Location: Malaysia Posts: 39 Rep Power: 14	Hi all, I wish to simulate partial porous MCHS in fluent. May I know how to initialize two fluid zone that move together from inlet at the same time in fluent ?

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Two questions on Fluent UDF	Steven	Fluent UDF and Scheme Programming	7	March 23, 2018 04:22
heat transfer with RANS wall function, over a flat plate (validation with fluent)	bruce	OpenFOAM Running, Solving & CFD	6	January 20, 2017 07:22
Alias problem when starting FLUENT from command line	batch_error	FLUENT	0	May 24, 2012 09:20
Fluent 12.0 is worst then Fluent 6.2	herntan	FLUENT	5	December 14, 2009 03:57
Problems in lauching FLUENT	Lourival	FLUENT	3	January 16, 2008 17:48

All times are GMT -4. The time now is 23:28.