CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   FLUENT (https://www.cfd-online.com/Forums/fluent/)
-   -   DPM and mesh requirements (https://www.cfd-online.com/Forums/fluent/133205-dpm-mesh-requirements.html)

amiralia April 11, 2014 15:24

DPM and mesh requirements
 
Hello everyone,
What are the mesh requirements for spray modelling using the discrete phase model (dpm) in FLUENT. Is there any limitations on the grid size? Should the cell size be greater than the particle or droplet diameter?
Thanks

amiralia April 15, 2014 14:46

Does anyone here have experience in spray modelling?

Barzanoni July 7, 2014 04:13

Hi
the grid size must be lower than the diameter of injector, of course in the vicinity of the injector.
you must fine the mesh as far the breaking of the droplets happen.


All times are GMT -4. The time now is 07:44.