|April 15, 2014, 17:21||
Join Date: Aug 2013
Posts: 10Rep Power: 5
Hi all ...I am using DPM Ijection to model sparay break up and I am facing two Problems here, Iam using group injection with unsteady particle tracking,fixes flow rate and diameter range.
1_I am not sure I completely understand how fluent calculates the Velocity for Injection. For example i know that my flow rate is 0.5 gr/s and for calculation of the velocity i use m'=rho*A*v (A is Injector Diameter) but does the fluent uses the same thing for obtaining the velocity since it injects stream of particles instead of a continues jet? my concern here is about the area, what area should be used here, injector area or area occupied by n numbers particles streams in one line.
2- I am using fixed diameter range here but after 3 iteration my diameter changes and particles diameter would increase , i am not modeling collision here and it doesn't matter if i use rosin rambler or linear distribution. i get the same result
I would aprreciate if anyone could help me here
|Thread||Thread Starter||Forum||Replies||Last Post|
|injection problem||Mark New||FLUENT||0||August 4, 2013 01:30|
|Dpm injection mass flow rate||diamondx||FLUENT||0||November 22, 2012 14:04|
|DPM injection mass flow rate||kingpots||ANSYS||0||November 22, 2012 12:12|
|On DPM injection properties.||akr||FLUENT||4||October 23, 2006 10:54|
|DPM Injection Parameters||Hendawi||FLUENT||0||June 13, 2002 09:41|