|
[Sponsors] |
April 15, 2014, 23:57 |
Heat transfer between two bodies
|
#1 |
Member
Join Date: Oct 2011
Posts: 80
Rep Power: 14 |
I have two blocks separated by a small distance. I initialize the bodies with 30 degrees and patched one body at 500 degrees. I am trying two methods to solve this.
I create the two bodies and fluid domain, then create interfaces where required. Another is selecting all bodies on Design modeler and making them as a single part. This creates them as walls with coupled condition for thermal. Are these methods correct and same? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Error finding variable "THERMX" | sunilpatil | CFX | 8 | April 26, 2013 07:00 |
Question about heat transfer simulation | Anna Tian | Main CFD Forum | 0 | January 25, 2013 18:53 |
Modelling the heat transfer during compression and cooling of natural gas | pano | Main CFD Forum | 0 | December 10, 2010 15:53 |
Heat Transfer in Porous Medium | eryan | STAR-CD | 0 | September 28, 2010 13:14 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |