Problems with Simulation
1 Attachment(s)
Hey Guys,
im really new to CFD-Simulation. Though i dont have acces to the Ansys Customer Portal i just started trying some things... Right now I´m doing a 2d-Simulation of a compression in a chamber. Attachment 30183 I use Ansys Workbench 14.5 and designed the half of the geometry(axissymetric) and the mesh with Ansys.I seperated the geomatry in 5 surfaces and connected them with interfaces. I used quadrilateral meshing with a higher density near the interfaces. Mesh Check was positive. In the setup I used Dynamic Meshing,In-Cylinder-Motion and Layering as Mesh-Method. When I start the the calculation i get following message: Error: replace_c_in_f_layering: cell of wrong type or NULL cell detected at layering zone. Now I have a few questions: How can i fix this proplem? When i check my Zone Motioten...is it normal that I can only see the top surface that is not deformed? How can i get acces to the data of the Ansys Customer Portal to do some Tutorials? If I use the Mesh-Motion function i get the message: Note: zone-surface: cannot create surface from sliding interface zone. Creating empty surface. Is this a big problem? If you have some tips for me I would like to hear them. Thanks Guys |
Tried to use different Meshes, but im getting the same message as before...
any ideas what could be the problem? |
My simulation seems to work now, but during the calculation i get another error...
Error writing "| gzip -2cfv > C:\Users\xxxx\xxxx\xxx\xxx\dp0\FFF\Fluent\FFF.1-1-01200.cas.gz". Anyone knows what this is? |
All times are GMT -4. The time now is 10:15. |