 |
 |
 |
|
|
|
[Sponsors] | ||||
April 25, 2014, 00:51
|
Low H2 release during gasification
|
#1 |
|
Senior Member
Bharath kumar
Join Date: Apr 2009
Posts: 169
Rep Power: 18  |
Hi to all,
I am doing Biomass gasifier simulation. (bagasse and H2O as oxidizer) Non Premixed combustion -> Pdf table approach Heat Source - 800K constant wall temperature With this simulation, i plotted H2 mass fraction at outlet. I am getting 1 to 2% H2 (CO - 50%,CO2-5%,CH4-8%,H2O-35%) as output, whereas in experimental results i am getting 52% H2. Could any body suggest some solutions to increase H2 release? Thanks in advance |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Release of foam-extend-3.0 | hjasak | OpenFOAM Announcements from Other Sources | 2 | September 21, 2014 08:08 |
| Openfoam Ubuntu 12.04 Unmet dependencies | slls33 | OpenFOAM Installation | 10 | April 9, 2013 05:16 |
| Extend Project Release 1.6-ext | hjasak | OpenFOAM Announcements from Other Sources | 33 | July 14, 2011 19:54 |
| Diesel combustion simulation ( Heat release rate) | venkatesh | Siemens | 2 | April 29, 2009 08:38 |
| Multicomponent fluid | Andrea | CFX | 2 | October 11, 2004 06:12 |
Linear Mode
