|
[Sponsors] |
April 29, 2014, 08:52 |
Change Dynamic Mesh Options in Calculation
|
#1 |
Member
Join Date: Apr 2014
Location: N/A
Posts: 47
Rep Power: 12 |
Hey Guys,
I´m simulating a Compression in an RCM with Ansys Fluent. I use Dynamic Meshing with the In-Cylinder-method. I try simulate the Compression with the same velocity profile as I get from experimental data. For example that i`d like to simulaten the first 1800 time steps with 1080RPM(0.05° timestepsize->180°). When this calculation is finished i want to change my setting to 2400rpm. But when I start the calculation again my angle is changs lets say form 270 to 360?? What did i forget? I attached my In-Cylinder -Settings Unbenannt.jpg Hope you can help me Starter |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dynamic mesh motion based on calculation | Detian Liu | OpenFOAM Running, Solving & CFD | 0 | January 13, 2014 07:09 |
Dynamic Mesh moving interface help | akash.iitb | FLUENT | 0 | August 23, 2010 23:53 |
Combine several dynamic mesh options | daniels | OpenFOAM Running, Solving & CFD | 3 | January 28, 2009 12:27 |
Convergence moving mesh | lr103476 | OpenFOAM Running, Solving & CFD | 30 | November 19, 2007 14:09 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |