|
[Sponsors] |
May 3, 2014, 17:00 |
new origin on inlet
|
#1 |
New Member
masoud
Join Date: Jan 2014
Posts: 4
Rep Power: 12 |
Hello Everyone,
I am writing a UDF for the inlet of the flow in my simulation, but I think the origin of the code and the origin of the geometry in fluent are not the same. how can I specify a new origin on the inlet to write the udf properly? Thank you |
|
May 4, 2014, 13:58 |
|
#2 |
Senior Member
Behrooz Jamshidi
Join Date: Apr 2013
Posts: 110
Rep Power: 13 |
Hi
You can translate, rotate and scale the mesh in fluent:e.g Grid>Translate |
|
Tags |
origin udf |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
setting the correct format of nonuniform List<vector> for inlet in 0 Folder | cfdonline2mohsen | OpenFOAM Running, Solving & CFD | 8 | July 18, 2019 08:03 |
Total pressure and mass flow boundary condition at inlet | bscphil | OpenFOAM Pre-Processing | 3 | July 9, 2017 14:39 |
Inlet Velocity in CFX | aeroman | CFX | 12 | August 6, 2009 18:42 |
Apply UDF at inlet( not the origin of the geometry | Sandeep | FLUENT | 0 | March 29, 2006 19:14 |
Diffusion component at inlet | Balaji | FLUENT | 2 | August 8, 2005 07:37 |