|
[Sponsors] |
May 23, 2014, 12:56 |
Question about domain connectivity
|
#1 |
Member
cfd^2
Join Date: Mar 2013
Posts: 31
Rep Power: 13 |
Hi,
I have two domains, one inside other. I need to assign different materials to each one, so I declared different names to them when I created the geometry in designmodeler. When I open the model in Fluent I see two different BC for each surface of the interior domain. I eventually saw that if I gave the same name to the two domains in designmodeler this issue disappears and there is only one BC for each surface. But, since I need different materials it does not match my goals. I would like to know if there is any problem when duplicate BC are obtained... Moreover, I need to know if I have to setup the same conditions for each duplicated BC. Regards. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
Floating point exception: Zero divide | liladhar | CFX | 11 | December 16, 2013 04:07 |
Different diffusivity for additional variable in Fluid and porous domain | ftab | CFX | 4 | June 27, 2012 13:03 |
Question about making a variable function of proprities of onother variable ? | rafiktharwat | CFX | 0 | March 26, 2011 14:23 |
General question concerning porous domain | Boris Tobias | CFX | 0 | November 19, 2010 04:13 |