CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > FLUENT

Adding Named Selections

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   June 4, 2014, 16:33
Default Adding Named Selections
  #1
New Member
 
Join Date: Jun 2014
Posts: 1
Rep Power: 0
Matty_A is on a distinguished road
I have found if I add the named selections within mesher after the Fluent solver has been opened it causes issues in Fluent. In other words, if I forget to add the named selections before starting Fluent is there any way to add these and then run fluent without starting over in workbench.

Thanks for any insight.
Matty_A is offline   Reply With Quote

Old   June 12, 2014, 07:18
Default
  #2
Senior Member
 
Gonzalo
Join Date: Mar 2011
Location: Argentina
Posts: 122
Rep Power: 16
gfoam is on a distinguished road
Mmm, I don't think you can do this because, when FLUENT starts it checks all the boundaries and if they don't have a explicit name and they are adjacent to each other, FLUENT will sew most of them and will put a default name to each cluster of walls. So, if this doesn't serves to you you will have to do all again in your mesher. Regards
Gonzalo
gfoam is offline   Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
y+ and u+ values with low-Re RANS turbulence models: utility + testcase florian_krause OpenFOAM 114 August 23, 2023 06:37
only 1 of many named selections not showing up in cfx pre mihirbhagat CFX 2 April 26, 2019 05:56
[OpenFOAM] Native ParaView Reader Bugs tj22 ParaView 270 January 4, 2016 12:39
Named Selections Issue vitor ANSYS Meshing & Geometry 5 February 7, 2011 15:30
Problem with compile the setParabolicInlet ivanyao OpenFOAM Running, Solving & CFD 6 September 5, 2008 21:50


All times are GMT -4. The time now is 01:14.