 |
 |
 |
|
|
|
[Sponsors] | ||||
July 1, 2014, 11:49
|
No Boundary Layer
|
#1 |
|
Member
Join Date: Apr 2014
Location: N/A
Posts: 50
Rep Power: 13  |
Hey together,
i have a problem in my thesis. I simulate the flow in a cylinder. Of course I want to have a No-Slip Condition at the walls. So i choose it under Shear-Condition-> No Slip But in my results there is no boundary layer for the velocity at the wall? Do you have an idea where the problem could be? I attached a picture where you can see the problem. |
|
|
|
|
|
July 2, 2014, 02:50
|
|
#2 |
|
Member
Join Date: Apr 2014
Location: N/A
Posts: 50
Rep Power: 13 |
Could it be that the mesh is not fine enough at the boundary? But anyway...shouldn´t the first layer be a boundary layer because of the no-slip condition?
|
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 10:38 |
| Low Mixing time Problem | Mavier | CFX | 5 | April 29, 2013 01:00 |
| Grid Independence of Boundary layer | Luigi_ | Main CFD Forum | 0 | December 14, 2011 14:42 |
| Boundary Layer Question | scottneh | STAR-CCM+ | 3 | September 30, 2010 15:21 |
| [Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 05:15 |
Linear Mode
