left-handed faces on the sliding interface -- CFD Online Discussion Forums

July 16, 2014, 03:54	left-handed faces on the sliding interface	#1
alirezame Member Join Date: Nov 2013 Posts: 57 Rep Power: 12	hi guys, I am simulating a 3D centrifugal compressor, at first I got a convergence solution with steady mode, (moving reference) and now I wanna simulate in unsteady mode, (mesh motion). when I wanna check the rotation before running,(mesh motion preview), I face with this warning in fluent: Warning: Failed to correct face handedness of 520 out of 672 left-handed faces on the sliding interface zone 29. any suggestion ? Many thanks,

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Other] Mesh Importing Problem	cuteapathy	ANSYS Meshing & Geometry	2	June 24, 2017 05:29
[snappyHexMesh] No layers in a small gap	bobburnquist	OpenFOAM Meshing & Mesh Conversion	6	August 26, 2015 09:38
Left handed faces created by adaptive mesh	RagingPotato	FLUENT	0	April 3, 2012 12:29
RPM in Wind Turbine	Pankaj	CFX	9	November 23, 2009 04:05
Replace periodic by inlet-outlet pair	lego	CFX	3	November 5, 2002 20:09

All times are GMT -4. The time now is 17:45.